Extra View / XtraView Setup in Durbanville
XtraView lets you run more than one decoder on a single subscription instead of paying for a second account. It is not a plug in job. The dish needs the correct LNB, each decoder needs its own feed, and the decoders have to be linked with a heartbeat cable and then paired in the right order. Get any of that wrong and the second decoder shows an error or drops off after a few days.
We do the physical side and the pairing together. That means checking what LNB is on your dish, running the extra coax and the heartbeat cable along a route that suits the building, terminating with compression connectors, then calling the link through and testing both decoders on live channels before we leave the property.
What is included
- Existing dish and LNB checked for XtraView capability
- Separate feed run to each decoder position
- Heartbeat cable installed between the linked decoders
- Compression connectors used at every termination
- Decoders paired and tested on live channels
How we do it
What the setup involves
An audit of the existing dish and LNB, the cable runs to each decoder position, the heartbeat link between the boxes, and the pairing itself. Where there are already spare cables in the wall we use them if they test clean. Where the run has to be made, we agree the route with you first, because on a finished house the cable path matters as much as the electronics.
Cable routes in Durbanville houses
Newer estate homes here are face brick with tiled roofs and usually have a reasonable roof void to work in, which makes a clean run from the main lounge to a bedroom straightforward. Double garages with a room above are the awkward ones, because there is often no void to cross. On the older larger stands the second TV can be a long way from the first, and we would rather measure that run before quoting than surprise you with it.
Estate rules and shared roofs
In a gated complex the roof is usually common property, so pulling a new cable across it needs body corporate consent even though the work is inside your own unit. We ask about that when you book so the visit is not wasted at the gate. Where consent is not going to happen, there are usually internal routes through cupboards or trunking that keep the job compliant and still tidy.
Faults on an existing XtraView
If a linked decoder has stopped working, the common causes are a disconnected or damaged heartbeat cable, a failed splitter fitted where a multiswitch is needed, or a subscription change that broke the link. We test the feeds first, then the link, then the account side. Most are back up the same visit. We quote before we come out and confirm on site.
Common questions
Extra View / XtraView Setup in Durbanville: your questions answered
How many decoders can I link on XtraView?
It depends on the decoder models and the LNB on your dish, and the rules set by the subscription. In practice most Durbanville homes we set up run a main decoder plus one or two extra rooms. Tell us which decoders you already own when you book and we will confirm what your combination supports before any work starts.
Do all the decoders need to be in the same house?
Yes. XtraView is designed for decoders on one property, linked by cable, on one subscription. It will not work between your house and a separate address. A cottage or flatlet on the same stand is normally fine, which matters on the bigger older properties and smallholdings on the edge of Durbanville where the second TV sits in an outbuilding.
Why does my second decoder keep losing the link?
Nearly always the heartbeat cable or a feed problem. A cable stapled through the shield, a connector pushed on rather than compressed, or a splitter used where the system needs a multiswitch will all give an intermittent link. We meter both feeds, check the heartbeat run end to end, and correct whichever one is at fault.
Can you add XtraView to a dish you did not install?
Yes, that is most of this work. We check the dish, the LNB and the existing cabling, then tell you what has to change. If the LNB is a legacy type it has to be swapped and the dish re-peaked on a meter afterwards. Email info@dstvdurbanville.co.za with your decoder models for a quote.
Book extra view / XtraView setup in Durbanville
Monday to Saturday across Durbanville and the northern suburbs, with emergency callouts when a business is down.